Smith & Wesson K Frame Model 10 Trigger .265" Used Part K101032
$24.99
Skip to product information
Smith & Wesson K Frame Model 10 Trigger .265" Used Part K101032
$24.99
Smith & Wesson K Frame Model 10 Trigger — .265" Wide | Used | Part #K101032
Factory OEM trigger for Smith & Wesson K Frame Model 10 revolvers, .265" wide trigger face. Controls the firing sequence in both single-action and double-action operation. Genuine S&W factory part in used condition.
This listing is for the trigger only — hand not included. Condition: Used, factory original.
Specifications
- Part Number: K101032
- Frame: K Frame
- Model: Model 10
- Caliber: .38 Special
- Trigger Width: .265"
- Material: Steel
- Condition: Used / Factory Original OEM
Model Compatibility Chart
| Model | Caliber | Notes |
|---|---|---|
| Model 10 | .38 Special | Verify dash number and trigger width before ordering |
Trigger geometry and width can vary between production runs and dash numbers. Verify your revolver’s dash number (stamped on the frame under the cylinder crane) and confirm .265" trigger width is correct for your model before ordering. The hand is a separate component — ensure your existing hand is compatible with this trigger before installation.
Function
The trigger controls the firing sequence in both single-action and double-action modes. In double-action, pulling the trigger cocks and releases the hammer in one motion while the hand rotates the cylinder. In single-action, the trigger releases the pre-cocked hammer. Worn or damaged triggers cause inconsistent pull weight, poor reset, and unreliable double-action operation.
Installation Note
Professional gunsmith installation required. Trigger fitting involves sear engagement geometry, trigger return, and timing verification with the hand and cylinder. Do not attempt without proper tools and training.