Smith & Wesson Revolver Pinned Front Sight Black Serrated Ramp .296" Height — Factory New Part 038110000

Smith & Wesson Revolver Pinned Front Sight — Black Serrated Ramp, .296" Height, Factory New OEM Part

Genuine factory new Smith & Wesson OEM pinned front sight featuring a black serrated ramp profile. The serrated ramp design breaks up light reflection across the sight face, reducing glare and providing a clean, high-contrast sight picture in bright conditions. At .296" height, this is a taller blade suited for longer barrel lengths or models requiring a higher sight for proper point of impact. A direct OEM replacement for worn, damaged, or missing pinned front sights on Smith & Wesson revolvers.

Specifications

• Part Number: 038110000
• Manufacturer: Smith & Wesson
• Part Type: Pinned Front Sight
• Profile: Serrated Ramp
• Height: .296"
• Finish: Black matte (glare-reducing serrations)
• Mounting: Pinned (requires pin)
• Condition: Factory New — genuine OEM part

Serrated Ramp vs. Partridge Profile

• Serrated Ramp (this sight): Sloped ramp profile with horizontal serrations across the face. Reduces glare in bright light. Traditional look for classic revolvers. Best for general shooting and hunting.
• Partridge (flat top): Flat-topped blade with a square, crisp edge. Preferred for target shooting and precision work. Available in .168" (Part# 038180000) and .228" (Part# 038370000) heights.

Compatibility

This sight is designed for Smith & Wesson revolvers that use a pinned front sight configuration. It fits a wide range of J, K, L, and N Frame revolvers equipped with pinned front sight ramps. The .296" height is typically used on longer barrel configurations. Common compatible models include:

• K Frame: Model 10, 14, 15, 17, 18, 19, 48, 66, 67 (pinned sight variants, longer barrels)
• L Frame: Model 581, 586, 681, 686 (pinned sight variants)
• N Frame: Model 27, 28, 29, 57, 629 (pinned sight variants, longer barrels)
• J Frame: Select models with pinned front sight ramps

Note: Verify your specific model, barrel length, and required sight height before ordering. Sight height directly affects point of impact — use the S&W sight height chart to confirm the correct height for your barrel length and model.

Installation Notes

• This listing is for the sight blade only. The pin is not included — the sight must be drilled to accept your existing pin or a new pin.
• The sight blade slides into the front sight ramp and is secured by a cross pin through the ramp and sight base.
• Some fitting may be required for optimal seating and alignment.
• Professional gunsmith installation recommended for proper fit, alignment, and pin installation.