Smith & Wesson Model 31 .32 S&W Long Cylinder - J723
$129.99
Skip to product information
Smith & Wesson Model 31 .32 S&W Long Cylinder - J723
$129.99
Smith & Wesson Model 31 Cylinder
Used Smith & Wesson cylinder identified for a J Frame Model 31 revolver chambered in .32 S&W Long. This listing is for the cylinder shown; no extractor, ejector rod or other components are claimed unless visibly included.
Product Details
- Brand: Smith & Wesson
- Model: 31
- Listed frame: J Frame
- Caliber: .32 S&W Long
- Part type: Revolver cylinder
- Condition: Used / surplus
- Part number: J723
Model Compatibility
| Model | Frame / Caliber | Compatibility | Required Checks |
|---|---|---|---|
| Smith & Wesson Model 31 | J Frame / .32 S&W Long as listed | Model 31 application; exact dash revision not identified | Match cylinder length and diameter, chamber count, center-hole dimensions, extractor interface and ratchet geometry |
| Earlier Model 31 or pre-model .32 Regulation Police | May use earlier I-frame dimensions | Not assumed compatible | Do not substitute by caliber, appearance or model family alone |
| Other .32-caliber J Frame revolvers | Different models, chambers and revisions | Not established | Exact dimensional and engineering-revision verification required |
Compatibility warning: Smith & Wesson cylinder and extractor geometry can vary by model and engineering revision. Confirm the revolver's stamped model and dash number before purchase.
Installation and Safety
A revolver cylinder is not a drop-in part. A qualified gunsmith must inspect chamber condition and fit the complete cylinder assembly, then verify headspace, endshake, barrel-cylinder gap, timing, carry-up, bolt engagement and chamber-to-bore alignment before firing. Used parts may show normal finish wear and handling marks; the photographed item represents the part and condition offered.